Oil Gas 3PE Pipeline Girth Welding Coating Heat Shrink Sleeve

Chat Now
Product Details

Oil Gas 3PE Pipeline Girth Welding Coating Heat Shrink Sleeve


                                INTRODUCTION
PE heat shrinkable tape (sleeve) is composed of cross-linked polyethylene back and special heat melt adhesive. Heat melt adhesive has good bonding with PE back, steel pipe and Fusion bonded epoxy (FBE layer). By heating PE back shrinks, adhesive layer melts, and closely wraps around pipe joints, then it forms together with FBE a firm and continuous anti-corrosion body. It is resistant to corrosion, wear, impact, UV and aging, easier to be operated.
 
Wraparound products
Application area:
It is mainly used for wrapping around pipe, anti-corrosion of kinds of pipe joints, and repairing pipes.
For example: Oil and gas pipe, PU insulation pipe, 3PE/2PE steel pipe.
 


TEST PROCEDURE AND TEST RESULT                              

TEST PROCEDURE

1.  Clean the steel pipe and heat it by fire till over 80 ℃

QQ Photo20170606134540.jpg

2.  Paint the steel pipe with Primer (mixed with A&B)

QQ Photo20170606134950.jpgQQ Photo20170606135000.jpg

3. Fire heat the heat shrink sleeve, be attention to start heating from middle of the sleeve, but act from up and down, and gradually move from middle to two sides of sleeve, in order to drive air out of the sleeve, after finish heating, the good result is that there is about 1-2mm hot adhesive melt at the edge of sleeve.

QQ Photo20170606135047.jpgQQ Photo20170606135056.jpg

TEST RESULT

1. Test result after cooling about 40 minutes.

  Peel strength to primer is over 100N per 2cm(till the end of the spring balance). at 30.7℃

  Co-adhesive: Half-half. 

QQ Photo20170606135130.jpg

2. Test result after cooling about 24hours. 

  Peel strength to primer is over 172N per 2cm at room temperature about 30.7℃

  Co-adhesive: Half-half. 

QQ Photo20170606135142.jpgQQ Photo20170606135155.jpg

3. 2. Test result after cooling about 24hours. 

  Peel strength to primer is over 9.2kg/90N per 1cm at room temperature about 30.7℃

  Co-adhesive: Half-half. 

QQ Photo20170606135340.jpg

CO-ADHESIVE APPREARANCE

QQ Photo20170606135351.jpgQQ Photo20170606135403.jpgQQ Photo20170606135423.jpg

Huashida Machinery, with over 14 years' experience, is one of the professional oil gas 3pe pipeline girth welding coating heat shrink sleeve manufacturers in China. Offering the customized service, we warmly welcome you to get the high qualified products from our factory.
Feedback